Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts occur every year, based on OSHA and HRSDC reports. A lot of these mishaps are caused by operator error. Lack of appropriate equipment check and maintenance results in many others. Forklift maintenance and operation is not just the cause of personal injuries, but also of property damage. Forklifts can damage building structures, overhead pipes and sprinklers, and other machinery when improperly used. The following daily inspections should be performed in order to lessen the chance of forklift accidents.
Turn the engine off prior to inspecting different fluid levels: engine oil, fuel, hydraulic oil, coolant and brake fluid. The tires should be checked for signs of wear and tear. Check the tire air pressure. Check the forks' condition. The load backrest should be attached firmly. Do a visual inspection of the top-clip retaining pin and heel. Then carry out an inspection of the mast chains, hydraulic hoses, cables and stops. Make certain that the finger and overhead guards are attached firmly.
LP forklifts have propane tanks that have to be inspected for signs of rust, corrosion or damage. Test the battery's electrolyte levels and charge. All belts should be checked for wear. Check to make certain the owner's guidebook is kept on-board the forklift inside a storage compartment. Test the seat belt to make sure the latches are secure. Check the hood latch to ensure it is functioning as it should.
To make sure there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate at once. Test the accelerator and the steering controls. The service brake and the parking break should be correctly working.
The drive control and tilt control must be inspected to ensure proper functioning in both reverse and forward. Check the functioning of the hoist and lowering control, and the attachment control. Check the lights and horn. After that check the wipers, heater and defroster to make sure they are functioning well. Inspect each and every gauge to ascertain that it is reading within functional limits.